| USB and HRCAP PLL Module (PLL2)In addition to the main system PLL, these devices also contain a second PLL (PLL2) which can be used toclock the USB and HRCAP peripherals. The PLL supports multipliers of 1 to 15 and has a fixed divide-by-two on its output.PLL2 may be clocked from the following three sources by modifying the PLL2CLKSRCSEL bitsappropriately in the PLL2CTL register:•INTOSC1 (Internal Zero-pin Oscillator 1): This is the on-chip internal oscillator 1 and provides a 10-MHz clock. If used as a clock source for HRCAP, the oscillator compensation routine should be calledfrequently. Because of accuracy requirements, INTOSC1 cannot be used as a clock source for theUSB.•Crystal/Resonator Operation: The (crystal) oscillator enables the use of an external crystal or resonatorattached to the device to provide the time base. The crystal or resonator is connected to the X1/X2pins.•External Clock Source Operation: This mode allows the reference clock to be derived from an externalsingle-ended clock source connected to either GPIO19 or GPIO38. The XCLKINSEL bit in the XCLKregister should be set appropriately to enable the selected GPIO to drive XCLKIN.NOTEFor proper operation of the USB module, PLL2 should be configured to generate a 120-MHzclock. This will be divided by two to yield the desired 60 MHz for the USB peripheral.HRCAP supports a maximum clock input frequency of 120 MH |
 |
|
您当前位置是：产品大全 >> 电子元器件 >>
集成电路(IC)
免责声明：以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，www.qy6.com对此不承担任何责任。如有侵犯您的权益，请来信通知删除。
联系信息
